Dosing Pump Timer, Automatic Passivation Timer

While Dosing Pump Timer or Timer for Dosing of chemical, Dosing Pump Controller,
It works in 4 steps
1. Passivation Dipping time
2. Buzzer activating and auto-off time
3. Chemical Dosing in ML
4. Setting of no. of cycles after that dosing to be repeated again.
it operates automatically by hand sensing of the operator or by material bucket sensing

Set Value of Passivation Time  : Dosing Pump Timer

Push SET Button Once
use the UP and DN buttons to adjust the required value, Press the ENT button to save Passivation Time.

Setting Buzzer Time

Push SET Button Twice, use UP and DN buttons to adjust the required value, Press the ENT button to save Buzzer activation Time.

Setting Quantity of Chemical to be the dose at once

Push SET Button Three times, use UP and DN buttons to adjust the required value, Press ENT button to save Quantity to be dose in ML.

Setting Repeat cycle difference

Push SET Button Fourth Time, use UP and DN buttons to adjust the required value, Press ENT button to save no of difference between 2 dosings.

Setting Set Min / Sec : 

Push SET Button with ENT at Once, switch ON the Power, use UP and DN buttons to Select the required value, Press the ENT button to save
Set Decimal Point
Press SET and DN Button at Once, Switch ON the Power, Set Decimal Point if required, Press ENT button to save

Other Products in This Category:Dosing Pump Timer

1. Dosing Pump 6 LPH
2. Dosing Pump 10 LPH
3. Thirty LPH Dosing Pump
4. TDS Controller Dosing setting
5. Dosing Pump Controller by Sensor
6. Passivation Dosing Timer
7. Dosing Pump Timer
8. Conductivity Controller Dosing setting
9. PH Controller with Dosing Quantity and delay
10. Automatic pH Dosing System

Other Products in This Category:Dosing Pump Timer

1. Dosing Pump 6 LPH
2. Dosing Pump 10 LPH
3. Thirty LPH Dosing Pump
4. 60 LPH Dosing Pump
5. TDS Controller Dosing setting used to maintain TDS
6. Dosing Pump Controller by Sensor
7. Passivation Dosing Timer: used for dosing of passivation addition by counting of jigs and set ML according to consumption average.
8. Conductivity Controller Dosing setting
9. PH Controller with Dosing Quantity and delay
10. Automatic pH Dosing System
11. Dosing per KWAH :- Hence it also called as dosing per amp Hour, useful for automatic dosing of making solution in zinc plating and crome plating to maintain level as per consumption